It depends on the fader type. A dead motorised fader on a digital console is a $40-$120 part plus two hours of labour. Dead faders on a console with no parts supply turn a $600 bargain into a $600 paperweight.
Daily Q&A
Storing speakers badly destroys surrounds and voice coils within a season. Keep them upright, dry, between 10 and 30 degrees C, and cycle them with low-level signal every 60 days to keep the suspension supple.
Burnt-smell, discoloured PCBs around the output stage, non-matching transistors, and fan filters full of dust are the four tells. Any amp that has been repaired with mismatched output devices will drift and eventually fail.
Plan on $2,800-$4,500 total for speakers, subs, amplification, console, and cabling for a 200-guest room. Spending $1,500 gets you sound; spending $4,000 gets you a rig that survives 40 bookings a year without repairs.
Yes, with conditions. Mismatched used speakers work fine as separate zones or fills, but never as a stereo pair handling the same signal. Sensitivity differences of 3 dB or more will make one side audibly louder all night.
A used line array cabinet costs $800-$2,500 per box while a comparable point-source speaker sells for $250-$600. The gap is rigging hardware, amp channels per box, and the fact that arrays only sell in sets of four or more.
Usually not. Look at the rear panel: if it reads 100-240V, 50/60 Hz, you need a $3 plug adapter and nothing else. Only single-voltage gear — say 120V-only into a 230V country — needs a real step-up or step-down transformer,…
Sea freight from China costs $1,800-$3,800 for a 20ft container, which holds 40-60 PA boxes. Air express runs $4.50-$8 per kg, so a 20 kg speaker costs $90-$160 to fly. Under 10 units, air usually wins; above 15, sea pays…
Buy used studio monitors only if the surrounds are intact and you can hear them at your listening level. Aged surrounds rot in 8-12 years and caps drift, which shifts the crossover point. Below $300 a pair, the saving rarely…
Check the jog wheels, then the crossfader, then the USB and media ports. Those three parts carry 70% of the risk on used DJ gear: a worn jog encoder is a $120-$300 repair and a dirty crossfader makes a $3,000…
