Description
A JBL KP4010, used, in stock. Price on request. If you already know the KP series, you know what this is: a passive two-way box with a proper compression driver on a rotatable horn, a 10″ woofer, and nothing inside that needs a laptop. Stock photos would tell you less than ours do — the photographs in this listing are of actual units from our warehouse, including the rear connector panel and the drivers with the magnet removed.
What the photos in this listing show
We photographed these boxes properly, so you can check the parts instead of trusting a spec sheet:
- The rear panel is legible, with the model marking, impedance rated at 8 ohms, and two NL4 sockets marked IN and THRU — the second one is a genuine loop-through, which matters when you are daisy-chaining four boxes a side.
- The compression driver is the JBL 2408H-2, photographed with its label intact. This is the part that fails first on used KP boxes when they have been run hard, so we show it rather than describe it.
- The woofer is the JBL 5041735 unit at 8Ω, again photographed from the magnet side. Both are the original parts, not substitutes.
- The crossover is shown in situ, not hidden behind a panel, so you can see the boards have not been re-soldered or bypassed.
The 2408H-2 driver is the reason a used KP4010 is worth buying at all. Plenty of boxes in this price bracket use a cheap piezo or a generic driver that sounds harsh at 3 kHz and dies at 40 % of rated power. This one does not.
Related on this site: JBL EON1500 15″ and our DiGiCo SD12 if you are building a full rig.
What the KP4010 is good at
It is a workhorse box: fills, side hangs, delay positions, small club mains, and the kind of corporate gig where you need vocal intelligibility at the back of a flat-floored room without a line array and a rigging budget. The rotatable horn means you can hang it horizontally and still point the pattern where you want it.
The honest limitation: a 10″ two-way is not a subwoofer, and it is not a long-throw box. It will not carry a 2,000-capacity room on its own. Pair it with subs for anything with kick and bass, and use two or three per side if the room is wide. If you are expecting a KP4010 to replace a 12″ or 15″ main, you will be disappointed — that is what the larger KP models are for.
Condition
Used and working. Cosmetically these are warehouse boxes, not showroom pieces: the textured black finish has scuffs and handling marks, the grilles have the usual small dents, and some cabinets have paint touch-ups. The cones are intact with no tears or punctures, the surrounds are pliable rather than cracking, the horns are not chipped, and the connectors are clean.
We have opened one up to photograph the internals, so you can see the crossover and the driver magnets rather than taking our word for the condition. If you need a specific quantity, tell us how many cabinets and we will photograph and test that exact set before you pay — matching a set by serial number and condition is worth ten minutes of our time and saves you a headache at load-in.
What you get, and what you do not
The cabinet with its driver complement. No flying hardware, no covers or bags, no NL4 cables, and no pole mounts unless we confirm it in writing. If you need the speaker poles or the wall brackets, ask — we can usually source them.
Shipping
These ship as individual cartons or as a pallet for multiples; both are cheaper than you might expect if you take a quantity, because one pallet costs less than four cartons. Tell us the destination country, the quantity, and whether the invoice is going to a company or an individual, and we will quote freight properly rather than guessing.
Boxes ship on a pallet, strapped edge-on, with corner protection — the grilles are the vulnerable part in transit, so we package for that.
Frequently asked
Is it active or passive?
Passive. Two NL4 sockets, IN and THRU, 8 ohms nominal. You need an amplifier or a powered mixer with the right power per channel.
Is this one cabinet or a pair?
This listing is one cabinet. We have multiples in stock — ask for a price on a pair or a four-pack, which is how most people actually buy these.
Can I see the serial numbers?
Yes, on request. We photograph them before dispatch so you have a record of what you bought.
Will it work with my existing JBL system?
If you are running KP-series boxes already, yes — same connectors, same impedance. Tell us your amp and we will confirm the load per channel before you buy.
What is the warranty?
Used equipment is sold as inspected and described. We test before dispatch, photograph every item, and will tell you what we find rather than what you want to hear. Ask about the terms that apply in your country.
Price on request — send your destination, the quantity you need, and what you will be driving them with, and we will quote with freight included.
