Used 18-inch subwoofer drivers change hands for $60-200 each. Check DC resistance, cone travel and magnet rust before paying. Neodymium drivers lose 2-4% flux per decade, but a clean one still beats a new budget driver on displacement.
Daily Q&A
Used analog consoles cost $8-25 per channel and survive bad operators. Used digital consoles cost $15-70 per channel and give you scenes, EQ on every input and built-in effects. Choose analog for simple repeatable shows, digital for anything with more…
A used Yamaha DM1000 runs $900-1,500 and still makes sense for fixed installs, houses of worship and small clubs. You get 48 channels, 16 aux buses and Yamaha preamps. You do not get Dante, and the USB card is slow…
A grade describes the outside of the box, not the inside. 'Like New' should mean no marks beyond one test session; 'Excellent' should mean light marks and fully working. Neither tells you about capacitor age, so ask five questions instead.
Most Chinese pro audio gear is 220-240V 50Hz, so a buyer in the UK, EU, Africa or Australia needs no converter at all. Buyers in the US, Canada and Japan on 110-120V need a step-up transformer rated at least 2x…
Sea freight from China to Europe or Africa for used audio gear runs roughly $120-260 per cubic metre LCL, with a 1 CBM minimum. Air freight is $4.50-7.50 per kg. The freight is rarely the surprise; the destination charges are.
Used studio monitors are a strong buy at 40-60% off when the pair is matched and the surrounds are intact. Active monitors hide their biggest risk inside the amp: capacitors that dry out and shift the crossover balance between two…
Used powered PA speakers usually save 40-60% against new, and the risk sits almost entirely in the amplifier module, not the drivers. Test for hiss at zero input and a power-up thump, and check whether the module is still available…
On used DJ equipment, check the crossfader before anything else. A worn crossfader is the single most common failure, and replacement parts for discontinued controllers often cost 20-30% of the whole unit.
Test a used microphone in 20 minutes: speak at 10 cm listening on headphones, run a 150-300 Hz sweep to catch a creased diaphragm, and compare output level against a known-good mic of the same model.
