Description
Two RCF ART 310 active two-way speakers, pulled from a working studio/PA rig. Both cabinets carry the same backpanel print and both power up on their own amplifier modules. The woofer on one unit had been opened for inspection before we listed it, and one of the seven photos is the amplifier board itself.
What is actually on the bench
Two matching RCF ART 310 units, black PP composite cabinets, steel grilles intact on both. The backpanel reads RCF, ART 310 and ACTIVE SPEAKER SYSTEM. Below the moulded handle you get an IEC power inlet, an XLR input, a jack input, an XLR link output that lets you daisy-chain the second box off the first, and the level and EQ trims.
Cabinet corners show normal road wear rather than impact damage: a small scuff on one back panel edge, dust in the grille mesh, a bit of paint missing on the handle recess. Drivers are original and the surrounds are intact with no tears or hardening.
Why this model still gets bought
The ART 310 was RCF’s workhorse 10-inch two-way for club installs, hotel ballrooms, gyms, houses of worship, small stages and rehearsal rooms — anywhere you want a box that goes on a pole, on a stand, or on its side as a floor wedge. Compared with a 12-inch box it is 12 kg and easy for one person to carry up stairs. Compared with a 15-inch two-way it keeps the midrange cleaner for vocals, which is why the 310 stayed popular with speech and acoustic acts.
For export buyers the practical point is this: it is a self-powered box with a European-made 10-inch woofer and a mylar-dome compression driver, and RCF still sells service parts for the ART line. You are not buying a disposable plastic box.
Specifications
- Type: active two-way, self-powered, no external amp needed
- Woofer: 10-inch, 2.0-inch voice coil
- HF: 1-inch mylar dome compression driver, 1.5-inch voice coil
- Frequency response: 50 Hz – 20 kHz
- Max SPL: 127 dB @ 1 m
- Coverage: 90° x 70°
- Crossover: 1800 Hz, with DSP and FiRPHASE processing
- Amplifier: 800 W peak / 400 W RMS total (600/300 W LF, 200/100 W HF), convection cooled
- Inputs: XLR + 1/4-inch jack, balanced/unbalanced; XLR link out
- Controls: volume, boost, mic/line switch, soft limiter
- Cabinet: black PP composite, steel grille, 2 x M10 rigging points, top handle, pole mount
- Size: 537 x 337 x 315 mm (21.1 x 13.3 x 12.4 in)
- Weight: 12.2 kg (26.9 lb) each
Figures above are RCF’s published data for the ART 310-A MK4. The backpanel on these two units does not print the wattage or impedance figure, so I am not quoting a number off the sticker that is not there.
What you get and what is not included
Two cabinets. No stands, no pole mounts, no mains cables, no covers. If you need XLR leads and IEC cables for sea freight we can quote them as an add-on. Grilles and all original screws are present; the photo with the loose drivers shows the inspection we did, not a fault that needs fixing.
Condition notes, plainly
Both units power on and the amplifier modules respond to input. I have not run a full frequency sweep or measured SPL on either cabinet, so I am not claiming “tested to spec” — if you want a bench test with a measurement microphone and a written result before shipment, say so at enquiry and we will arrange it and send you the plots. Cosmetically both are strong used grade; one panel has a light scuff and one grille has dust in the mesh.
Shipping and export
Both cabinets ship from our warehouse on palletised freight, double-boxed with edge protection. Ocean LCL is the usual route for a two-box order to Europe, the Middle East, Africa or South America, and we can consolidate with other speakers, mixers or amplifiers on the same bill of lading. Tell us the destination port at enquiry and we will come back with freight and lead time; we handle the export paperwork, HS codes and the commercial invoice.
Price
Price is on request. RCF ART 310 units move quickly and the price depends on whether you take one box or the pair, and on the freight route — send us your port and quantity and we will quote you properly rather than posting a number that will not hold.
Related reading on this site: Peavey NC 110 passive 10-inch pair for a cheaper passive route, JBL KP4010 if you already own an amp rack, and the KP4010 bulk lot for a multi-box install. Full range on the shop page.
