Twelve to eighteen years is the honest range for a quality touring amplifier. Class AB designs with good capacitors reach 15 years comfortably; switch-mode amps often go longer because they use fewer, better-specified electrolytics. What kills them faster is heat and duty cycle, not calendar age alone.
What are the warning signs of tired capacitors?
- Bass that gets soft before it gets loud. Reduced capacitance means the supply sags on transients, so kick drums lose punch at high level while quiet passages sound fine.
- Hum that was not there before. 100Hz or 120Hz hum proportional to load is the classic symptom.
- Heat. The same amp in the same rack, running noticeably hotter than it did two years ago.
- Turn-on thumps. Slower, louder relay clicks indicate the supply is taking longer to stabilise.
- Physical bulging. Domed tops on electrolytic cans, or dried crust around the vent.
Physical inspection is worth more than any listening test. Open the lid and look at the tops of the big cans. Flat tops are fine. Domed tops are done, regardless of what it sounds like today.
What does a recap cost?
Parts for a full main-supply recap on a 4-channel touring amp run $120-250 if you buy decent 105C capacitors. Labour is 4-8 hours at bench rates, so $150-400 depending on where you are. Total $250-450 per amp, plus shipping if you cannot do it locally.
Compare that against replacement. A used 4-channel touring amp at $700-2,000 that needs a $400 recap is still far cheaper than a new one at $3,000-8,000. That is why recap work is routine in the rental world, not a sign of a dying amp.
Which amps are worth recapping in 2026?
Amps with strong transformers, simple class-AB output stages and available schematics. Lab.gruppen, Powersoft, MC2 Audio, Crown Macrotech and Camco all qualify, and their service documentation is either public or widely circulated. Amps with proprietary switch-mode modules and no published schematic are a gamble: if a module fails, you cannot fix it.
We list MC2 Audio T45 power amplifiers as a rack of ten, which is a telling format. Ten units of the same model is exactly what a rental company wants: one spare, shared parts, one schematic. Buying ten of one model beats buying five models of two.
How do you check an amp before buying?
- Serial number and service history. A serial that matches a known production run tells you the OEM parts used, and lets you find the right cap kit.
- Run it at load, not open circuit. Many faults only appear with a real 4-ohm load.
- Listen to channel 4. The last channel gets the least attention and shows the first signs of a tired supply.
- Check the fan and filter. A clogged filter is the single biggest cause of early capacitor death.
Should you pay less for an amp that needs a recap?
Yes, and by more than the recap costs. Deduct 25-35% from the price of a working equivalent, not 15%. The extra is for the risk that the recap reveals a second problem, which it often does: cracked solder joints, a tired relay, a fan past its life. Buying an amp sound-checked and working is worth paying a premium for.
Key Takeaways
- Touring amps last 12-18 years before a recap; heat and duty cycle matter more than age.
- Soft bass at high level and new hum are the listening symptoms; domed capacitor tops are the visual proof.
- A full recap costs $250-450 per amplifier in parts and labour.
- Recapping is worth it on amps with published schematics and available parts.
- Deduct 25-35% for an amp that needs recapping, because a second fault usually appears.
