Five minutes and three tools find most faults: a known-good XLR cable, a pair of headphones, and your own voice. Test cable first, then tap the body, then speak for 30 seconds, then listen at high gain. A rattle when you tap means a loose capsule mount, and that is a repair, not a bargain.
Most used microphones are not broken. They are just worn in ways the photo does not show: dented grilles, stretched capsule suspension, oxidized connectors. Those wear items are cheap to fix. The expensive failures are hidden until you gain up.
What should you test first?
The cable. Half the “dead microphone” complaints I hear turn out to be a cable with an intermittent pin 2. Plug the mic into a channel you already trust, with a cable you already trust. If you are buying in person and cannot bring your own cable, bring your own cable anyway. This one habit has saved me two bad purchases.
How do you check the capsule without opening it?
- Tap test. Tap the body lightly with a fingertip while monitoring at moderate gain. You should hear a dull thud, not a rattle or a ringing ping.
- Grille check. Look through the mesh at a light. Denting that touches the diaphragm is a fail.
- Smell test. A sweet, chemical smell inside the grille often means moisture damage.
- Rotation. On swivel-mount mics, the joint should hold position without sagging.
On condenser mics, also check for a pad or low-cut switch that clicks properly. A stiff or loose switch is a sign the mic has been handled roughly, and it is the cheapest thing to fix before it breaks a recording session.
What does a bad microphone actually sound like?
Three symptoms matter. Hiss that appears only when you speak means a dirty capsule or a failing FET, and the fix is a $150-300 repair or a replacement capsule. Dropouts when the cable moves mean a broken solder joint at the connector, which is cheap to fix. Low output versus a known-good mic of the same model means a tired capsule, which is not cheap.
The one that fools people: a mic that sounds fine at low volume and distorts at high SPL. That is a stretched diaphragm, and it will sound worse every month. Test at stage volume, not at speaking volume, if you plan to use it on a drum kit or a loud vocalist.
Is a used dynamic mic worth buying at all?
Dynamics are the safest used purchase in audio. An SM58 has no active electronics, a capsule that survives drops, and a body you can repair with a $25 cartridge. A used one at $45-70 is a fair deal. A used one at $30 with a dented grille is still fine; grilles cost $12-20 on their own.
Condensers are the opposite. They have high-impedance circuitry, capsule polarization, and a diaphragm measured in microns. A used condenser needs the test above plus a return window. No return window, no deal, regardless of the brand name.
How do you test a whole lot of used microphones?
Ask the seller to record one continuous take: each mic, spoken into at the same distance, with the model name said out loud. Then listen once on headphones and note any mic that sounds quieter or duller than the rest. This filters a lot of 20 in five minutes and costs the seller one phone recording.
If you are outfitting a venue, pair the mics with a small powered speaker cab and a used microphone category listing of matching stands and clips, because 20 mics without clips is 20 problems on opening night.
Key Takeaways
- Test the cable before the microphone; bad cables cause most dead-mic reports.
- Tap the body lightly. A rattle means a loose capsule mount.
- Hiss that appears only when speaking means capsule damage, a $150-300 fix.
- Used dynamics at $45-70 are low risk; used condensers need a return window.
- Ask for one continuous phone recording of every mic in a lot.
