Speak into the mic at normal level, then tap the body gently — rattles mean a loose capsule or debris. Inspect the diaphragm for dents, and check the connector for wobble. That covers 90 percent of problems in five minutes, no measurement gear needed.
Below is the full bench test I use, plus the counterfeit signs that matter most for popular models.
What is the basic test sequence?
- Connect to a known-good preamp and set a normal gain level.
- Speak at conversation distance — the level should be steady, not crackly.
- Tap the body and the grille; listen for buzz or rattle.
- Rotate the cable at the connector; any cutoff means a broken solder joint.
- Sweep the polar pattern by moving side to side — the tone should change smoothly.
What does a damaged capsule sound like?
Thin, dull, or distorted at high level. A dented diaphragm often sounds fine at low volume but distorts as you push it. If a used speaker or mic has been dropped, this shows up first. For condensers, hum or noise floor issues often mean a bad capsule or moisture.
How do you spot a counterfeit?
- Price — a genuine SM58 below $50 or an SM7B below $250 is suspect.
- Weight — fakes are often noticeably lighter.
- Grille — mesh is finer or coarser than genuine, and looser.
- Serial — check it against the maker’s warranty checker.
Does age matter for microphones?
Less than for speakers or desks. A 1990s dynamic mic with a clean capsule can outlast a five-year-old cheap one. Condensers age faster because of moisture and capsule tension. Dynamic mics are the safer used buy.
Key Takeaways
- Speak-test and tap-test catch most used mic faults in five minutes.
- A diaphragm dented by a drop distorts at high level, not low.
- Genuine SM58 mics trade $60–80; anything under $50 is likely fake.
- Dynamic mics age far better than condensers.
- Always check the serial against the maker’s system.
