Speak into it at 5 cm, 15 cm and 40 cm, then tap the grille and shake the body gently. A healthy dynamic mic sounds the same shape at all three distances and makes no rattle. On wireless systems, add a full RF scan and two fresh battery sets – a false economy here costs $150 in new capsules later.
Testing a used microphone before you buy takes about six minutes per unit. It is the same test a rental house runs, minus the paperwork.
What does a capsule tap tell you?
Tap the grille with a fingertip and listen. You should hear a dull thud with no ringing and no rattle. A rattle means the capsule has come loose from its mount, which is a $120-250 repair on a Shure Beta capsule and often not worth it. Then blow gently across the grille: a dry, raspy response points to a corroded diaphragm.
Why does the cable matter more than the mic?
Because most “dead mic” reports are dead cables. Flex the XLR at both ends while speaking and listen for crackle or level drops. Wiggle the connector housing. A mic that cuts out only when the cable bends at the plug is a $15 fix, not a $200 mic.
On gooseneck models such as the Beyerdynamic Opus 29 S, flex the neck through its full range while speaking – a loose gooseneck can be tightened, a broken internal wire cannot.
How do you test a wireless system properly?
- Scan the full RF band on the receiver and note which frequencies are clean in your area.
- Walk the transmitter 30-40 m away with line of sight and listen for dropouts.
- Swap to a fresh battery mid-test and watch for a restart glitch.
- Check the body pack’s belt clip and battery door hinge, both common breaks.
- Pair an in-ear system and verify both channels, not just one.
In-ear systems need a different test entirely: feed audio into the transmitter and confirm both receivers, including the Shure PSM 600 EP6T/P6R pair, deliver stereo without hiss on either bodypack.
What about phantom power and condensers?
Ask the seller to run the mic on 48 V for at least five minutes. Old condensers can pass audio cold and then go noisy once the capsule charges. Listen for hiss with no input after four minutes of phantom. If the seller cannot test phantom, assume the mic is untested.
Which faults should end the deal?
- Intermittent output that changes with cable angle, even after a cable swap.
- Rattle from inside the body, or a capsule that moves under the grille.
- Scratched or replaced thread on the XLR connector.
- Wireless units with no frequency scan and no way to verify tuning.
Bulk microphone lots are listed in the microphones category with serials; ask for a short recording of each unit before committing.
Key Takeaways
- Three distances plus a capsule tap catches most faults in under six minutes.
- Most dead-mic reports are cable faults, so flex the cable under load.
- Wireless gear needs a full RF scan and two battery sets.
- Run condensers on 48 V for five minutes before judging them.
