Daily Q&A

What should you check first when buying used DJ equipment?

Answered on November 9, 2026

Platter play, crossfader, USB ports. In that order. Everything else, including cosmetic scuffs and the stickers on the jog wheel, is noise. The three items above are the parts that wear with use, and they are the parts where replacement cost approaches a third of the used price.

How do you check platter bearings?

With the deck off, press the platter edge and let it spring back. Then rotate it slowly by hand and listen. A healthy platter turns with a faint, even whirr and stops without a wobble. A worn bearing makes a grinding sound at one point in the rotation, and the platter will rock slightly side to side.

Do it on both decks. On a used pair, one deck usually has far more hours than the other because DJs favour a side.

What does a worn crossfader cost?

ItemCost
Replacement crossfader (standard)$25-60
Replacement crossfader (magnetic, pro)$120-250
Full mixer service$80-150
Deck platter bearing set$40-90

Test the fader by slowly moving it through the throw with music playing. Listen for crackle in the middle third, which is where scratching sits. A fader that only crackles at the extremes is still usable for club work.

Why do USB ports matter so much?

Because deck firmware increasingly runs off USB and because a dead port on a controller is often a board-level repair. Bring a USB stick with a couple of tracks on it and plug it into every port. The deck should recognise it within about five seconds. If it takes thirty, the port is on its way out.

Also check whether the deck reads the stick after a power cycle, not just the first time. Warm ports behave differently.

What else is worth ten minutes?

  • Headphone jack: plug in, wiggle, listen for channel dropout
  • Line and phono inputs: test both, they fail differently
  • Knob detents: a loose cue knob is a $5 fix, a bent shaft is not
  • Screen brightness on controller models, since a dim OLED is a warning

Is used DJ gear worth it at all?

Yes, at 45 to 60 percent of new for gear under 6 years old. Below that, you are buying someone’s problem. And skip anything with a proprietary battery, since replacement cells become unavailable around year 7.

Browse the used DJ gear category for current listings, and check the used amplifiers category if your rig needs more power.

Key Takeaways

  • Platter bearings, crossfader and USB ports are the three checks that matter.
  • A pro magnetic crossfader costs $120 to $250 to replace.
  • USB ports should enumerate a drive in about five seconds.
  • 45 to 60 percent of new is the fair range for gear under 6 years old.
  • Avoid proprietary batteries, which become unavailable around year 7.

How do you check a mixer against a deck for value?

Mixers lose value faster. A 6-year-old 4-channel mixer at $250 to $400 holds less of its original price than a deck from the same era, because controllers keep adding features that make old mixers look crude. If you are splitting a budget, spend on the decks and buy the cheapest mixer that tests clean.

Exception: scratch DJs. For scratching, the crossfader is the instrument, and a $250 magnetic fader is worth more than a bigger jog wheel.

What does a realistic used setup cost?

RouteCostRisk
2 used decks + used mixer$700-1,400Bearing wear
Used all-in-one controller$450-900Single point of failure
New entry controller$350-600Lower resale

What should you ask the seller directly?

  • How many hours per week was it used, and was it in a club or a bedroom
  • Has it ever been serviced, and by whom
  • Are the original firmware files and the license transferable
  • Can you see a photo of the underside, where drinks spill