Description

Short answer: these are four loose 18-inch neodymium low-frequency drivers built by B&C Speakers for the L-Acoustics KS28 subwoofer. They are drivers, not cabinets — no boxes, no amplification, no crossover, no DSP. In stock, price on request, and we have not measured them, so treat the specs below as what the part is, not as a test report on these four units.

Most listings for this part either pretend it is a catalogue B&C product or quietly skip the part where you cannot just screw it into any 18-inch hole and expect KS28 performance. We are going to be clearer than that, because the four things that decide whether a used driver is worth buying are measurable and none of them are on a spec sheet.

Is there such a thing as a “B&C KS28” datasheet?

No. This is the part buyers get wrong most often, so it is worth saying plainly: B&C custom-designed the KS28 driver for L-Acoustics. There is no B&C catalogue entry, no retail SKU, no published B&C spec page. Serial numbers and any service route belong to L-Acoustics, not to B&C.

What that means in practice depends on which side of the counter you are on. If you are repairing KS28 cabinets and need an exact replacement, this is the right part and the only question is condition. If you were hoping to find a cheap 18-inch neo driver with a nice published curve to drop into a home-built sub, you are shopping in the wrong category — the tuning lives in the L-Acoustics box, and the driver was never sold separately on spec.

What the KS28 driver actually is

  • Size: 18 inch / 46 cm low-frequency transducer, neodymium magnet
  • Built for: the L-Acoustics KS28 dual-18 active subwoofer, two per cabinet
  • Nominal impedance: 8 Ω per driver in the KS28 system
  • System bandwidth it serves: 25 Hz – 100 Hz, cabinet max SPL 143 dB with LA12X amplification
  • Construction: long-excursion motor, double suspension, aerated cast chassis
  • Cabinet it came out of: 1218 x 607 x 787 mm, 102 kg — useful if you are matching a rig

Read those numbers the way a system tech would. A 25 Hz lower limit and 143 dB do not come from the driver alone; they come from two of these in a tuned box fed by a big amplifier and a preset that knows what the box does. Put one driver in a generic cabinet and you get an 18-inch subwoofer of unknown tuning, which is a perfectly usable thing — it is just not a KS28. We would rather you know that before the freight bill arrives.

How do you check four used drivers before buying?

Four tests, thirty minutes, a multimeter and a phone. If a seller will not let you do these, that is your answer.

  • DCR reading. A healthy 8 Ω nominal driver reads roughly 5.5 to 7 Ω on a meter. An open circuit means a burnt coil; a reading well under 5 Ω means shorted turns. Test all four and write the numbers down — matching values across the set is almost as useful as the values themselves.
  • The push test. With the driver face-up, press the cone gently and evenly with two fingers. It should move smoothly and return without rubbing. Gritty or scratching feel means the voice coil is dragging in the gap, and that driver is done.
  • The click test. Touch a 1.5 V battery to the terminals for a fraction of a second. A clean click in both directions means the coil is intact and moving. No sound, or a faint rattle, and you have found the problem.
  • Surround and spider. Look for foam rot, cracks at the cone-to-surround joint, and sag in the spider. Neo drivers of this size rarely suffer surround rot, but a cabinet that sat in a hot container for a month can still leave its marks.

We have not run any of these on our four units. The photos are close enough that you can judge the cones, surrounds and chassis condition yourself, and if you want a photo of a meter reading across the terminals, ask before ordering and we will shoot one. We would rather promise a measurement we can deliver than print a number we invented.

Who buys loose KS28 drivers, and who should not

Three groups actually buy these. Rental houses with KS28 inventory and a blown driver, who need four spares rather than a new cabinet at full price. Repair shops doing insurance and venue work, where matching an existing rig matters more than the driver’s pedigree. And a smaller group building custom subwoofers who want a serious neo motor and are willing to design the box around whatever they end up with.

The group that should walk away is anyone expecting plug-and-play. There is no preset, no cabinet, no amplifier and no manufacturer support path through B&C for this part. If you want a subwoofer you can unbox and use, buy a complete cabinet — our K-array KO70 dual 21-inch active subwoofer is a finished, powered solution, and the Bose TopSub module covers the smaller-room end of the same problem.

What do used KS28 drivers cost?

New KS28 cabinets run into five figures for a pair, so loose used drivers trade in a wide band — commonly 350 to 700 USD each depending on region, provenance and whether the seller can show a DCR reading. A matched set of four from the same cabinets, as here, is worth more per unit than four singles from four different rigs, because a rental house buying spares wants consistency more than it wants a bargain.

Freight is the part people forget. Each driver is roughly 12 to 15 kg, so four of them in a single crate from Guangdong to a European port usually lands in the 200 to 320 USD range by sea LCL before insurance and destination charges. We can build one crate for all four and quote it properly — that is very often cheaper than four separate small parcels, and it protects the cones properly.

For a wider look at what else is on the shelf, browse the speaker listings or the PA systems category, where most of our touring stock sits.

Quick Answer

  • Four loose B&C-built 18-inch neodymium LF drivers from L-Acoustics KS28 subwoofers.
  • Drivers only: no cabinet, no amplifier, no crossover, no preset.
  • 8 Ω nominal per driver; the 25 Hz–100 Hz and 143 dB figures describe the complete KS28 system, not a loose driver.
  • Not measured, not power tested — ask for a DCR photo and we will send one.
  • In stock now, price on request, freight quoted separately per crate.

Repairing a KS28 rig, or building something around a serious neo motor? Send us the details — tell us how many drivers you need, whether you want them crated together, and the destination port. We answer within one working day.

Excellent In Stock

B&C KS28 18-Inch Neodymium Subwoofer Drivers, Set of Four (Used, In Stock)

Ask for price

FOB price from China. Shipping quoted per destination.

Listed on October 23, 2026
Learn more

Related Q&A & Guides