Daily Q&A

What does ‘excellent condition’ actually mean on a used speaker?

Answered on October 27, 2026

On used speakers, “excellent condition” should mean four things: original cones with no recone, cabinet corners not crushed, grilles straight, and the electronics load-tested. If the listing shows only a front photo in good light, you have not seen anything yet.

What is the difference between excellent, very good and used?

There is no industry standard, which is the whole problem. Reputable exporters work from a rough five-tier scale. Anything under “good” is a parts unit in disguise. Here is how the grades should map to what is inside the box:

GradeCosmeticDriversElectronics
Like newNo visible marksOriginal, factoryFull test, all functions
ExcellentMinor scuffs, corners intactOriginal, no reconeTested at rated power
Very goodScratches, one corner dentOriginal, foam agingTested at low level
GoodPaint chips, rusty screwsMixed or reconedPower-on only
For partsBrokenFailedNot tested

Which detail exposes a fake grade fastest?

The cone. Ask for a photo of the back of the driver with the magnet visible. Original K-array or JBL drivers have casting marks and a clean dust cap. A recone shows glue rings at the surround and a slightly off-centre cap. That single photo tells you more than ten paragraphs of description.

Second fastest: the cabinet corners. Crushed corners mean the box has been dropped repeatedly, which stresses the joint where the baffle meets the sides. A speaker that has been dropped often rattles at 80-120 Hz and you will not hear it until you push it.

How do I test a grade before it ships?

Ask for a video, not photos. Three things in it: a sweep from 40 Hz to 16 kHz at moderate level, each driver playing alone if it is a two-way box, and the amp plate photographed while running. If the seller sends a video of music playing, that hides every rattle. A proper test takes four minutes and any real exporter can film it.

Compare what you receive against a known-good reference. Our K-array KF12 self-powered 2-way speaker listing shows the level of detail a serious grade should come with, including the amp module and cabinet corner photos.

What should a lower grade save me?

Roughly 15-20% per grade step. Excellent to very good is a small discount. Very good to good should be 30% off, because you are buying a unit that will need foam or a driver within two years. Good to for-parts is 50%+ and only makes sense if you already have a donor unit.

What should be in writing before you pay?

Three lines. The grade, the phrase “drivers original, no recone”, and a return window. If a seller resists putting the grade in writing, the grade was marketing. Ask for the serial numbers too, since they tell you the production year and whether a pair actually matches, which matters more than most buyers expect when they later need a replacement driver.

Photographs of the packaging stage matter as much as the grade itself. A well-graded speaker shipped in a cardboard box arrives as a poorly graded one.

Is ‘like new’ ever worth the premium?

Rarely. The premium is usually 25-40% over excellent for a box that will get scratched on its first load-out anyway. The exception is studio or install gear that never leaves a room. For touring speakers, buy excellent and put the savings into flight cases.

Key Takeaways

  • No universal grading standard exists. Ask for the criteria in writing.
  • A photo of the driver magnet from behind exposes recones instantly.
  • Demand a frequency sweep video, not a music clip.
  • Each grade step down should cost 15-20% less.
  • Skip ‘like new’ premiums on touring speakers, spend it on cases.