Daily Q&A

Do you need a voltage converter for imported audio gear?

Answered on November 19, 2026

Most Chinese used pro audio gear is built for 220-240 V at 50 Hz, so buyers in Europe, Africa, the Middle East and Australia need only a plug adapter. Buyers in the US, Canada, Japan and parts of Latin America need a step-up transformer, sized at 1.5 to 2 times the amplifier’s continuous current draw.

The mistake I see most is someone buying a USD 25 travel converter for a 500 W amplifier. It will work for a week and then fail, sometimes taking the amp with it.

What voltage does Chinese pro audio run at?

RegionMainsWhat you need
EU, UK, Africa, Middle East220-240 V, 50 HzPlug adapter only
Australia, NZ230-240 V, 50 HzPlug adapter only
USA, Canada120 V, 60 HzStep-up transformer
Japan100 V, 50/60 HzStep-up transformer
Brazil, parts of LatAm127-220 VDepends on region

How do you size a step-up transformer?

Read the amplifier’s rated power on the rear plate, not the marketing figure. A 2 × 500 W class-D module typically draws 250-400 W from the wall at normal use. Size the transformer at 1.5-2 times that, so 600-800 VA for one box, and double it for a pair running hard.

Frequency is a separate issue. A 50 Hz transformer will run on 60 Hz mains, but motors and fans spin 20% faster. On a speaker with a temperature-controlled fan, that is usually harmless. On a turntable, it is not.

What breaks when the voltage is wrong?

  • Under-voltage — amps clip early, DSP boards reboot randomly.
  • Over-voltage — power supply capacitors vent, sometimes loudly.
  • Cheap converters — square-wave output makes transformers hum and run hot.
  • Wrong plug force-fitted — cracked socket boards, USD 80-150 to repair.

Can you rewire the gear instead?

Sometimes. Many pro amplifiers have dual primary windings, so a technician can reconnect them for 120 V in about 30 minutes. Ask the seller for a photo of the transformer label before assuming this works. If the amp has a switch-mode supply with a wide input range (100-240 V), you need nothing at all.

Check the rear plate before you buy. Our K-array KF12 listing states the mains configuration, and the Yamaha DM1000 is a good example of a console with a switchable supply.

Key Takeaways

  • Chinese pro audio is typically 220-240 V, 50 Hz, needing only a plug adapter in most markets.
  • In 100-127 V countries, size a step-up transformer at 1.5-2× the amp’s wall draw.
  • A 2 × 500 W class-D box draws roughly 250-400 W from the wall.
  • Travel converters with square-wave output damage audio gear.
  • Ask for a photo of the transformer label before assuming a rewire is possible.