Daily Q&A

How much are used 18-inch subwoofer drivers worth in 2026?

Answered on October 31, 2026

What is a used 18-inch driver worth?

**Neodymium 18-inch drivers run 150-320 USD each used; ferrite versions run 90-180 USD.** That is roughly 30-50% of new price. Recone cost of 90-180 USD per driver is the figure that decides whether any individual driver is worth buying.

Neodymium holds more value for one reason: weight. A neodymium 18 weighs 6-9 kg against 14-18 kg for ferrite, and in a four-driver sub that is 40 kg less per cabinet, which changes everything from rigging loads to freight.

Why do drivers fail, and how do you test one?

Most used driver failures are mechanical: a torn surround, a shifted cone from being dropped, or a burnt voice coil from an amp clipping. A burnt coil smells of burnt varnish and will not move freely.

Push the cone gently with two fingers at opposite points. It should move smoothly through 5-8 mm of travel with no scraping. A scraping sound means the coil is rubbing, and that driver is a recone candidate at best.

Then test electrically. A multimeter across the terminals should read near the rated DC resistance; a 8-ohm driver reading 2 ohms or open circuit has a damaged coil. Finally, play 40-60 Hz at moderate level and listen for a buzz that is not in the cabinet, and for excursion that is asymmetric in one direction.

What do the numbers look like?

Neodymium 18″, usedFerrite 18″, usedNew neodymium 18″
Unit price150-320 USD90-180 USD450-950 USD
Weight6-9 kg14-18 kg6-9 kg
Recone cost90-180 USD70-140 USDwarranty
Rated power800-1,600 W AES500-1,200 W AESvaries

Notice the last column. A new neodymium driver at 450-950 USD means a used one at 250 USD plus a 150 USD recone is still under half price, which is why drivers move quickly when they appear in good condition.

When is a used driver a bad buy?

When the surround is torn and the recone kit is discontinued. When the magnet has shifted, which shows as a cone that will not move freely and is not fixable cheaply. And when the seller cannot tell you the model number, because drivers that look identical can differ by 200 W of power handling.

Also skip drivers sold as “matching set” from different models. Four cabinets with four different drivers will not tune the same, and a sub stack needs matching behaviour more than it needs maximum power.

How should you plan a sub order?

Work backwards from the room. Two 18-inch drivers in vented cabinets cover a 200-300 person club at 105-110 dB(A) at the mix position. Four gives headroom for outdoor events. Buy all the drivers you need at once from one lot, because matching drivers later at the same price is rare.

Our BCS KS28 18-inch neodymium driver set of four is listed as a matched set, which is the format that makes most sense for a sub stack. If you are buying bare drivers, the speakers category shows what they pair with, and the shop lists current lots. Ask for a resistance reading on each unit before you commit.

Key Takeaways

  • Used neodymium 18-inch drivers sell at 150-320 USD; ferrite at 90-180 USD.
  • Push the cone 5-8 mm: any scraping means a recone at 90-180 USD.
  • A multimeter reading far off rated resistance means a dead coil.
  • Buy matched sets from one lot; mismatched drivers ruin sub stack tuning.