Budget $90-220 per used 18-inch neodymium driver in good order. A new B&C or RCF 18-inch neodymium woofer runs $280-700 depending on power handling, so used stock at 30-45% of new is normal. Ferrite drivers are cheaper used, $50-120, but weigh 8-12kg more each, which hits your freight bill.
Why does neodymium matter for shipping?
Weight, and only weight. An 18-inch neodymium driver weighs about 8-11kg; the ferrite equivalent weighs 18-25kg. For a set of four that is a 40-55kg difference, which matters when air freight runs $4-7 per kg. The magnetic performance is comparable; neodymium just lets you get the same flux in a smaller, lighter assembly.
One practical caveat: neodymium magnets lose strength at high temperatures. Drivers that have been run hard in a hot enclosure, or stored in a shipping container that crossed the tropics, can have measurably weaker magnets. Ferrite is more heat-stable. It is not a reason to avoid neo, but a reason to test.
How do you test an 18-inch driver?
- Free-air push test. Push the cone evenly and release. It should move smoothly with no scraping and return to centre without a rattle.
- Ohm reading. A healthy 8-ohm driver reads 6.2-7.2 ohms. 4-ohm versions read 3.2-3.8.
- Tap test. Tap the cone lightly. A dull thud is fine; a buzz means a loose dust cap or a delaminating spider.
- Look at the spider. The corrugated suspension should be intact and evenly glued. Lifted glue lines around the spider mean the driver has been over-driven.
- Check the magnet gap. Shine a light into the gap and look for rust or debris. Rust in the gap will destroy the voice coil within hours of use.
When is re-coning worth it?
Almost never on a used driver you are buying, often on one you already own. A re-cone kit for a common 18-inch pro driver runs $90-180 in parts, plus labour if you cannot do it yourself. On a used driver bought at $150, a re-cone doubles the cost and you end up near new price with no warranty.
The exception is a rare or discontinued model where the basket and magnet are valuable. In that case, re-coning makes sense because a replacement driver does not exist.
What do sets of four cost?
Sets sell at a premium because matched sets are genuinely more useful than four singles: they load identically, and a sub array needs identical units. Expect $420-900 for a matched set of four used 18-inch neo drivers, against $1,400-2,800 new.
We keep a matched set of B&C KS28 18-inch neodymium subwoofer drivers for exactly that reason. B&C KS28 units are matched to a specific cabinet design, so buying four from the same production batch means the whole sub array behaves predictably instead of one box lagging behind the others.
What about complete used subwoofers instead?
If you need cabinets as well as drivers, buying complete used subs is usually cheaper per output than drivers plus new boxes. A used 18-inch sub cabinet complete runs $350-700; a new empty cabinet of decent quality is $250-500 on its own before you add a driver. Only buy bare drivers when you already have good boxes and want to refresh them, or when cabinets are cheaper to build locally.
Key Takeaways
- Used 18-inch neo drivers cost $90-220 each; ferrite versions $50-120 but weigh 8-12kg more.
- Matched sets of four trade at $420-900 versus $1,400-2,800 new.
- Push test, ohm reading and a magnet-gap inspection catch most failures.
- Re-coning a used driver rarely pays; it pays on gear you already own.
- Buy bare drivers only when you already have cabinets worth refreshing.
