Daily Q&A

How much are used 18-inch subwoofer drivers worth per unit?

Answered on November 2, 2026

Used 18-inch subwoofer drivers are worth $80-260 each in 2026. Neodymium 18s sit at the top of that range because they weigh 9-12kg instead of 25kg and touring crews pay for that. Ferrite drivers usually land near $90-130. A recone kit is $60-150, so a driver with a rubbing voice coil is worth scrap value and not much else.

Why does magnet type move the price so much?

Weight is everything in touring. An 18-inch neodymium driver weighs about a third of a ferrite equivalent for the same output, which matters when a crew is loading 24 of them into a truck at 2am. That is the whole premium, and it is a fair one.

Ferrite is not worse sounding. It is heavier and cheaper to make. In a fixed install nobody cares, so buy ferrite and save the money.

What does a recone actually cost?

WorkCostNotes
Recone kit (18-inch)$60-150Parts only, brand dependent
Labour, recone shop$70-1201-2 week turnaround
Spider/frame inspection$0-30Often free with recone

Add that up and a $90 driver needing a full recone is a $250 driver. Sometimes that still works out, especially on a model whose recone kit is still produced. Check kit availability before you buy, not after.

How do you tell if a used driver has been overheated?

  • Discolouration on the coil former, visible through the spider gap. Brown or black means it ran hot.
  • Smell of burnt varnish near the magnet. You will know it.
  • Coil rub – push the cone straight down with two fingers. It should glide. Grit or scraping means an off-centre coil.
  • Tinsel leads that are stiff or repaired with solder blobs are a sign of a hard life.

Also measure DC resistance with a multimeter. A nominal 8-ohm driver showing 4.2 ohms has shorted turns somewhere.

Is buying a used set of four cheaper than one at a time?

Yes, and the discount is worth chasing. Single drivers from a failed project sell slowly; four matching units are attractive to anyone servicing a sub array. A set of four matching 18-inch neodymium drivers typically goes for 15-25% less per unit than buying singles over a few months.

We list drivers in sets for exactly this reason, like this BCS KS28 18-inch neodymium sub driver set of four. If you are rebuilding a sub cabinet, the used speaker cabinet range is worth scanning too, since a loaded cabinet often costs less than four bare drivers.

What is the wrong reason to buy used drivers?

Matching a model you cannot recone. Some discontinued drivers have no kit available anywhere, and you end up with four expensive doorstops. Before any purchase over $100, search the model number plus “recone kit” and confirm a supplier still lists it.

Key Takeaways

  • Used 18-inch drivers: $80-260 each, neo at the top, ferrite near $90-130.
  • A full recone adds $130-270, so factor that into any offer.
  • Check coil rub, smell and DC resistance before paying.
  • Set-of-four lots run 15-25% cheaper per unit than singles.