Daily Q&A

How to test a used microphone before you buy it?

Answered on October 25, 2026

Short answer: ten minutes and four tests. Tap the body for capsule rattle, sweep from 40 Hz to 15 kHz to hear diaphragm rub, wiggle the XLR to catch a cracked solder joint, and inspect the grill for rust or foam rot. Condensers also need 20 minutes on phantom power to prove they hold charge.

Microphones are the most-resold item in pro audio and the easiest to fake or hide damage on. A $300 dynamic mic that fell off a stand can look perfect and still have a shifted magnet.

Test 1: does the capsule rattle?

Hold the mic by the body, not the grill, and tap the base of the housing with one finger. You should hear a dull thud through the output, nothing else. A rattle or a loose buzz usually means the capsule mount has broken off. On an SM58-style mic, that repair runs $60-90, which is often half the used price.

Test 2: what does the frequency sweep reveal?

Play a sweep through a speaker and monitor the mic on headphones at moderate gain. Listen for a buzz at one frequency – that is diaphragm rub from a bent voice coil. Also listen for a drop in high end above 10 kHz. Dynamic mics lose top end with age as the diaphragm stiffens, and a mic that sounds dull will not fix itself.

Test 3: is the connector solid?

Plug in an XLR, then wiggle the connector side to side while someone monitors the output. Crackle or dropouts mean a cold solder joint or a worn connector. This is the cheapest repair on the list at $20-40, but it is also the most common cause of a mic cutting out mid-show.

Test 4: what does the grill hide?

Unscrew the grill if the design allows, or look through the mesh with a light. You are checking for two things: rust spots on the capsule, and disintegrating foam. Old foam turns to sticky dust that clogs the diaphragm and kills high frequencies. A new foam liner costs almost nothing; a corroded capsule means walk away.

What extra checks do condensers need?

  • Phantom power: run 48 V for 20 minutes, then listen for hiss or a fading signal. Capsules that lost charge drift and hiss.
  • Pattern switch: cycle omni, cardioid and figure-8 and confirm each pattern changes the tone.
  • Pad and low-cut: click both and confirm the level and tone change.
  • Shock mount: original shock mounts are $80-150 to replace when missing.

What price makes a used mic worth it?

A pro dynamic mic at $80-180 used versus $180-400 new is the sweet spot, provided the capsule is original. Condensers drop harder: a mic that listed at $800 new often sells for $350-450 used with the shock mount included. If the mount or case is missing, take another 20 percent off.

Buying bulk from an exporter only pays off if you are filling a mic locker. If you need a full kit of stands, cables, and cases, the microphone category page shows what else is stocked so you can consolidate one shipment instead of three.

Key Takeaways

  • Tap the body for capsule rattle before anything else.
  • A frequency sweep catches diaphragm rub and lost high end.
  • Wiggle the XLR to find cold solder joints – a $20-40 fix but a show-killer.
  • Check for rust and rotting foam under the grill.
  • Test condensers on 48 V for 20 minutes before you pay.