Daily Q&A

How do you test a used microphone before you buy it?

Answered on October 21, 2026

Do four things: tap the body and listen for rattle, sweep a sine tone to catch diaphragm rub, run phantom power on condensers, and swap the cable. Half of all “dead mic” reports are a bad cable or connector. Ten minutes on a bench saves you a $200 mistake.

What tools do you actually need?

  • A mixer or interface with phantom power and a level meter.
  • One known-good XLR cable and one known-good dynamic mic as reference.
  • Headphones that seal properly.
  • A phone with a tone generator app (1 kHz and a slow sweep).

No spectrum analyser needed. Your ears plus a reference mic catch 95% of problems buyers care about.

How do you test a dynamic mic?

Speak at a fixed distance and compare level against the reference mic with the same gain. Within 3 dB is normal. A 3-8 dB shortfall usually means a tired capsule or a partially shorted voice coil, and a capsule swap on an SM58-class mic costs $45-70 — more than many used units are worth.

Then tap the grille lightly with a fingernail. You should hear a dull thud, not a buzz or rattle. A rattle means a loose capsule mount, and that buzz will show up on loud stages.

What is different for condensers?

Phantom power changes the test completely. With 48V on, listen for hiss and crackle with nothing playing. A condenser that is quiet at low gain and noisy at high gain has a dirty capsule or a failing FET. Do not test condensers without phantom power and assume they are fine.

Check the capsule visually if the grille unscrews. Gold sputtering that has gone patchy is a bad sign, and humidity damage is common on mics stored in tropical climates without silica.

Which faults cost the most to fix?

FaultRepair costWorth fixing?
Bad cable / connector$8-25always
Dynamic capsule swap$45-70only on premium models
Condenser capsule clean$60-120usually
Condenser capsule replace$150-500rarely on used
PCB / FET repair$80-180model dependent

Why does the smell test matter?

Smoke and damp leave traces. A grille that smells of cigarettes or mildew tells you the mic lived in a club or a humid warehouse. Foam inside the grille degrades in humid air and sheds onto the capsule — that is the grit you hear on plosives.

Check the thread on the stand mount too. Cross-threaded mounts are cheap to fix ($5 clip) but they tell you how the mic was treated. If you buy in lots, check two units out of ten thoroughly and one from each box. The microphones category lists single units with connector photos, which is the part most listings skip.

Can you test remotely before shipping?

Partly. Ask for a video where the seller speaks into the mic, then taps the body, then shows the connector at the end. Insist the level meter is visible in frame. That combination rules out the three most common problems: dead capsule, loose mount, damaged connector.

What you cannot test remotely is long-term noise drift in condensers, so budget a 10-15% risk on any condenser bought unseen.

Key Takeaways

  • Always compare against a reference mic — a 3-8 dB drop means a tired capsule.
  • Test condensers with 48V phantom power on and nothing playing.
  • Swap the cable first; it causes more “dead mic” reports than capsules do.
  • Dynamic capsule replacement costs $45-70, condenser replacement $150-500.
  • For remote buys, require a video showing speech, a body tap and the connector.