A grade is only useful if the seller tells you what was tested. Like New should mean under 50 hours of use and no marks visible at arm’s length. Excellent means full function plus light cosmetic wear. Very Good allows dents and scuffs but no functional problem. Fair means it powers on and passes signal, yet needs service. If a listing says Excellent and lists no test results, treat it as Very Good at best.
What do UK buyers actually mean by “used speakers for sale, uk grade”?
UK trade listings borrow from photography grading, roughly: Mint, Excellent, Very Good, Good, Fair. Audio does not have an official standard, so every dealer invents their own. Two shops can both advertise “Excellent” and be one grade apart.
| Grade | Hours | Cosmetics | Function |
|---|---|---|---|
| Like New / Mint | under 50 | no marks at 1m | all tested, no faults |
| Excellent | 50-500 | light scuffs, clean grilles | all tested, minor knob wear |
| Very Good | 500-2,000 | dents, paint chips, logo wear | all working, some pots noisy |
| Fair | 2,000+ | heavy road wear | works, needs recone or service |
| For parts | unknown | broken | not tested |
Which checks separate a 9/10 from a 7/10 speaker?
- Cone and surround. Look for foam rot, small tears near the gasket, and dust-cap dents. A recone is $70-120 per 12-inch driver.
- Grille and cabinet. Rusted grille screws mean humid storage, which usually means corroded terminals inside.
- Horn diaphragm. Ask for a sine sweep video. A rubbing diaphragm buzzes at 3-5 kHz and is easy to hear on a phone recording.
- Power section. Thermal paste dries out after 10+ years. Ask if the amp module was ever serviced.
Does grade really change the price that much?
Yes, and not linearly. On a $700 new speaker, the gap between Excellent and Very Good is roughly $70-110. The gap between Very Good and Fair is often $200+, because Fair buyers inherit the recone cost. That is why an “Excellent” badge on a 2011 cab deserves suspicion — 15 years of club use rarely leaves a cabinet at arm’s length clean.
For a concrete example, look at the KF12 self-powered speaker listing. It states the grade, the unit count and the condition of the grilles in the same sentence. That is what a useful grade looks like: a badge plus evidence.
What should you ask before trusting a grade?
Three questions. Was it tested at full power for at least 30 minutes? Is the grade based on the cabinet, the drivers, or both? And what is excluded from the warranty? A seller who answers all three in writing is worth the extra 5-8% they charge.
Also ask for the serial photo. Serial ranges tell you the build year, and build year tells you which revision of the amp module you are getting. Nobody advertises that detail, but it matters more than a scuff on the corner. For mixers, the same logic applies to fader revisions and firmware — see the mixers category for cased units where revisions are listed.
Is a lower grade ever the better buy?
Often, yes. If you run a rental company and can recone in-house, a Very Good cab at 55% off is better value than a Like New one at 20% off. If you are reselling to end users who care about appearance, buy the highest grade you can and price accordingly. Grade is a logistics decision as much as a condition decision.
One warning: never accept a grade on a pallet lot without a per-unit count. “10 units, Excellent” can hide two non-working units, and by the time they land you own them.
Key Takeaways
- Like New = under 50 hours, no marks at 1 metre, all functions tested.
- Excellent allows light wear but no driver, horn or fader faults.
- Fair means it works and needs service — budget $70-120 per driver recone.
- Grade should change price by $70-110 between Excellent and Very Good on a $700 speaker.
- Ask three questions: test duration, what the grade covers, and warranty exclusions.
